A Western Star came into us for an engine rebuild. When it arrived, we flagged something separate straight away. The radiator support was broken clean in half, and we told the customer the truck really should not go anywhere until that was sorted.

The rebuild went fine. The support didn’t get done.

We did the rebuild, an out-of-chassis job where the engine comes right out, and put everything back together. But we still did not have a radiator support, and we said so. The customer needed his truck back, said he would make one up at the farm, and headed off across the paddock.

The homemade support never happened. And that is where the trouble started.

What the support actually does

On a Western Star, the radiator is braced by support bars, some running straight back and some on an angle to the same point, holding the top of the radiator steady. With the straight-back one broken and missing, the radiator had nothing holding that corner in place.

Crossing the paddock, every bump and jolt let the radiator rock backwards and forwards the whole way. On these trucks the hoses are firm and tight, with very little slack to absorb that movement. Big engines already put a lot of flex and torque through everything around them, and the support bars are there to stop exactly this kind of flexing. Without them, something had to give. In this case it split the top tank, the moulded plastic tank on the radiator, right up underneath where it had been flexing.

Sorted, and a warning worth heeding

The truck came back in, we replaced the header tank, and we made up a bar to get him home and going again.

The lesson is a small one that saves big money. Those support bars and their bushes are not decoration. When someone points out at a service that a support bush is gone or a bar is cracked, it is worth acting on. Left alone, it can crack a radiator, split a tank or blow a hose, and turn a cheap bracket into a big cooling system bill.

Book in today: 08 9353 1289