A customer brought in his Volvo FH13 with three separate complaints. Each one turned into its own job, and the last one is a good reminder of why we chase the cause rather than the first thing that looks likely.
Fault one: the dash playing up
The electronic air tank gauges were randomly dropping and coming back up, throwing low-air warnings all over the dash. The catch was the truck had full air the whole time. We tested everything and ported it out, and the air system was doing its job perfectly.
Out on a test drive the gauge dropped again, so I gave the top of the dash a light smack, and it came straight back up. That tells us the air is fine and the real fault is electrical, either a loose terminal behind the dash or the circuit board inside the cluster itself.
Fault two: the power steering
The moment I started it up, the power steering was whining its head off. Underneath, the box was dripping, leaking through the side shaft seal. So it is either a new box or we send this one off to be overhauled and it comes back like new.
Fault three: a clunk under load
This was the good one. The complaint was a clunk in the gearbox under load. So I took it out and tried everything to make it clunk, on and off the throttle, diff locks in, power divider in. Nothing in the driveline made a sound.
What I did notice was the suspension. It was so rough it was bouncing all over the place, bottoming out and bashing up through the seat on every bump. That was the clue.
The clunk was never the gearbox. Underneath, I found worn and flogged-out spring suspension bushes, play in the drag links, a worn tie rod end, worn front cab suspension mounts, king pin play, wheel bearing play, and worn cab ram bushes. The tie rod end was a beauty too. It wasn’t worn in the ball, it was worn in the hole it sits in, so the nut had come loose and it was rattling around inside.
Put all of that together and you get one big clunk, on every bump, every take-off, and every time the trailer kicks side to side.
Why it matters
If we’d taken the complaint at face value and started pulling the gearbox apart, we’d have wasted the customer’s money and never fixed the problem. The clunk had nothing to do with the gearbox. Only a proper look underneath was ever going to find it.
That’s the whole job. Find out what’s actually wrong, not just what it first sounds like.
Book in today: 08 9353 1289